Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
I have two sets, one on my sled and one on my wifes. I have had both brands of 36'' and dans are a far better design all around. Not sure his customer service can be matched. Just be sure to get an extra rod end. I didnt at first and payed for it. My fault. Saved my arm so it was easier to accept. Now i carry a spare in both sleds. you will not be disapointed.Just ordered the 36" kit from AI. Just one thing to say, Dan put up some real good service. It was a real pleasure to deal with him. If the product is as good as his customer care, then this should be of the best.
I have two sets, one on my sled and one on my wifes. I have had both brands of 36'' and dans are a far better design all around. Not sure his customer service can be matched. Just be sure to get an extra rod end. I didnt at first and payed for it. My fault. Saved my arm so it was easier to accept. Now i carry a spare in both sleds. you will not be disapointed.
Are you selling these? I assume it puts one at 37. Like the thought of this better than narrower arms. At its narrowest the spindle won't be outside ski.Hopefully this is easier to look at.
Are you selling these? I assume it puts one at 37. Like the thought of this better than narrower arms. At its narrowest the spindle won't be outside ski.
Teth-air... Taking the pivot of the ski off-axis would, to me, increase steering effort as you "swing" rather than "turn" the ski.
Just a thought.
.
so it is 1 1/2 offset? It looks like about an inch in your pics.
My ski stance is 36" center of ski to center of ski sitting on the floor. That would be at the narrowest setting possible. I'm not sure where guys are measuring from to get 38" as the narrow setting on a stock RMK? Looks great shortstuff! Rod ends look a little long but it might just be the picture. Just remember while the sleds in the air at full droop in the shop, check for binding turning the skies all the way both ways as well as clearance issues. If any of this happens go back to the instructions to be sure you set up properly. If your check list is complete I say you find some snow! Thank you.Here's some pics of installed 36" a arms. Don't have any measurements of height or anything. But I did measure center to center twice to be sure and with sled on stand so the arms at full droop. I get 36" and my skis are centered so I should be able to adjust to 35 or 37" right. Reading on this forum it says that 36 is with skis on narrow setting. And can adjust to 37 or 38" are we supposed to measure with sled on ground? And gasshockrepair is great to deal with. I've had Andy do allot of shock work for me over the years bikes and sleds. Very reasonable.
The ski stance is 39" to 41"