m8 turbo

So I bought this sled this past summer and was stoked to have a boosted sled. Rode it a couple times early season, and the first real ride, had it pretty well dialed in, it wasn't off by much. But it went down. It wouldn't start. It would fire, fire, backfire... etc. Got it off the mountain...

09 M8 with Twisted Pump Gas Turbo I can't figure this sled out. Sometimes it will run awesome, sometimes it will stall, sputter and puke. Sometimes, when it does it stall and sputter thing, if I cut the power to the temp sensor on the bottom of the motor, it will run fine until the ECU senses...

M8/Turbo guys. I need your help. I think my temp sensor went out, not sure though. Here's what happened: -Warmed up to 100 degrees -Started going down the road, temp gauge stops displaying -Turn around, hit a bump, turns back on. -I'm watching my gauges like a hawk never saw a temp above 120...

So I bought an 09 M8 Twisted Turbo (pump gas). Took it up Fairview to test it a little in the fields and parking lot. It just didn't sound right. I wasn't sure where the boost was set for so I backed it off and cranked it over time, but all the way cranked it only pulled 5-6 pounds??? Granted I...

Just got an '09 M8 with a pump gas twisted turbo. Just 1200 on the sled. Top end redone a couple hundred ago with forged pistons. This guy really knew what he was doing. I am new to turbos, so I just need a few questions answered, from you, I already have been told by him what the specs should...

I've got an 09 M8 with a BD RG kit. Sled has 4K miles and i installed an Innovate MTX-L AFR gauge but there isn't enough voltage to run it unless i unplug the headlights and intercooler fan, then it works fine. I wired it directly to the red/blue wire coming out of the factory aluminum finned...

2009 Arctic Cat Turbo Snowmobile - 09 M8 pump gas BD Turbo 162, EBC, inner cooler, TDR reads, Koso guage, 162 power claw, Holtz reworked shocks, BD vented side covers, RK tech hood riser, guage console riser/tilt billet bracket, handle bar riser forward 2". Sled has 1283 miles, great condition...

Just bought a 2009 M8 Boondocker RG Turbo 11psi built by VOHK with 3500miles. Reeds are original (haven't pulled them yet) so I want to replace them while I'm doing a top end and other stuff. What reeds should I get and are the OVS turbo reeds stops worth it? Stock? Boyesen? Something else...

Great Deal !! 09 M8 Turbo W/ inner Cooler (SOLD) 09 M8 BD pump Gas Turbo w/ inner cooler 162 powerclaw EBC with tps hook up BD turbo pipe, wrapped, also have stock one TDR Reeds 2011 head, also have stock head 0 miles on fresh top end BD vented side covers HCR diamond drive RK Tech hood...

I have for sale a complete OVS turbo kit with everything, Aero turbo, fuel presure reg, programer fuel map, clutch kit, culter primary adjusable weights all hoses, spare springs for turbo, booster fuel pump. complete. $3000

2009 M8 162" OVS turbo, bought in 2010 turbo put on this year, completely set up, adjustable gauge pod with boost gauge and AF digtal gauage shark skins, frog skins, 2010 Arctic Cat seat, OVS clutch kit fuel map programer, handle bar riser, Culter adjustable weights, new belt, windsheild bag...

Thought you guys might enjoy some of these hill climb GoPro videos. Had an epic trip last weekend in Alpine, WY and some of the footage turned out pretty well. Enjoy! I'm running a 2011 Arctic Cat M8 stage 3 Cutler Turbo.... http://www.youtube.com/watch?v=lpSW6F4aIZ4...

The entire sled is based off of a 2007 Yamaha Apex Mountain with 2475 miles. I upgraded the sled with reverse the first year I had it. I rode the sled stock for very 1st year as well. Since then I have upgraded the sled considerably. I have put 2000 miles on the sled with the turbo kit on it...

Drove my sled into my garage and swaped out the steering post out and went to start it and no spark. Fuel pump is making pressure, power is showing up on the Air Fuel but not the speedo gauge. I went through all of the connections and closely looked over the wiring and could not find anything...