Maptuner stage 2 results?

[Daniel475]

just curious what everyone is running for weight in their maptuner stage 2 and what pipe they went with ? thinking of bumping mine up from stage 1 to stage 2 and curious if the pipe is needed for sure , im running a diamond s titanium can right now ! thanks for the feedback guys have a good night

 

[ujstrelax]

I am sea level to 3000' and have my cluthing modified with 94-95 octane gas. I run stage 2 with only a exhaust can as I heard alot of people say the pipe temps take too long to get hot enough to work well. I have had great luck with 2022 stage 2 and 2023 stage 2 is insane power. Only time 2023 stage 2 was an issue was 35-40 degree weather with wet heavy snow. This threw my clulthing off in mid range. I reloaded 2022 stage 2 and finished out that ride no issues.

 

[Cycle850]

I am sea level to 3000' and have my cluthing modified with 94-95 octane gas. I run stage 2 with only a exhaust can as I heard alot of people say the pipe temps take too long to get hot enough to work well. I have had great luck with 2022 stage 2 and 2023 stage 2 is insane power. Only time 2023 stage 2 was an issue was 35-40 degree weather with wet heavy snow. This threw my clulthing off in mid range. I reloaded 2022 stage 2 and finished out that ride no issues.

What clutching set up did you find to work best with stage 2?

 

[madmax]

You dont need a pipe for stage 2, a can yes. You already have a diamond S can, you’ll be fine with stage 2. Or flash the maptune 23’ flash into your sled.

 

[Dynamo^Joe]

I would not touch the maptun recommended "Bowel Movement pipe" with a 10 foot pole. So that you can have your engine power peak moved around 200 rpms lower? HAH!!!
Right now your engine is running with a flat power peak of estimated 185hp @ 7900 & 185hp @ 8000 rpms....and that pipe will move the power peak lower to 77~7800.
The stock Y-& main pipe w/a DS can is one of, if not, the best combination exhaust for the money.

 

[firstkitty]

?this nails it . 100%

 

[ujstrelax]

What are some of your clutching set ups for low elevation and maptune stage 2? I am not sure on my helix but it is aftermarket, I have a 150-350 primary spring and zrp 75 gram adjustable ramps with 2,2,1 grams or magnets in them 2 at the heel and 1 at the tip. I am installing a 150/300 primary as I still see some spikes in wot rpm with the new tune. Would love to share others combo's