R
I have installed everything but the included wiring harness.
I have done this on the SP and XP sleds and have not had a problem.
However, I'm not finding the correct harness connector for the starter kit wiring harness.
This machine has a different type of REV/Start switch, as shown below.
It is zipped tied to the handle bar...…...
…. as apposed to this style that I have connected in the past.
Do I need to cut into the wiring and circumvent the harness connector?
Any suggestions would be appreciated.
Rick E.
I have done this on the SP and XP sleds and have not had a problem.
However, I'm not finding the correct harness connector for the starter kit wiring harness.
This machine has a different type of REV/Start switch, as shown below.
It is zipped tied to the handle bar...…...
…. as apposed to this style that I have connected in the past.
Do I need to cut into the wiring and circumvent the harness connector?
Any suggestions would be appreciated.
Rick E.
Last edited:
