R
ok guys i just installed the 180 hp kit from mountain perforamce, I rode for the first time yesterday and im in need of some clutch help. Currently installed in primary is blue/green/blue spring stock weights with 17.2 rivets in every hole,(this is what was recommended) new 14.5 rollers. The sled would start out good but half way thru the power would just fall off it was snowing so hard i couldnt see rpm numbers. Secondary is stock. Gearing is setup at 20t drive gear/ 40t driven gear. Im just wondering if i take out rivets in the primary maybe start with taking one out of each weight or change gearing....? just not sure where to go i ride about 4500-6500 elevation i weigh about 250 lbs. Any help would be graetly appreciated. I ran a bit better than a stock sled yesterday not good!!! Thanks in advance