I'm in the midst of this conversion using OEM parts. I bought the tunnel extension, bumper, flap, taillight, cooler, board edges and gussets. The pic below if one of the few I can find of a new cooler mounted. I have a few questions:
Is there typically a gap between the rear of the cooler and the rear of the tunnel?
Are there supposed to be shields over the hoses?
How is the taillight wiring routed?
I'm getting close to finishing and want to make sure I wrap up these little details properly.
Pic from here: http://www.snowestonline.com/forum/showpost.php?p=1854238&postcount=23
Is there typically a gap between the rear of the cooler and the rear of the tunnel?
Are there supposed to be shields over the hoses?
How is the taillight wiring routed?
I'm getting close to finishing and want to make sure I wrap up these little details properly.
Pic from here: http://www.snowestonline.com/forum/showpost.php?p=1854238&postcount=23