R
What do you think of a Two Stroke 700cc Maico Super Moto Timbersled. It would be wicked with a Lectron Carb and a Timbersled kit. You wouldn't know what season to pray for Winter or Summer.
700cc Maico Super Moto Timbersled
- Thread starter reflextruckliners
- Start date
-
- Tags
- 700cc maico timbersled
B
been waiting to see someone rock a maico for a long time!
C
Not plug and play!
Somebody would have to do the work to get the right hand drive to work.
Plus fit kit.
Somebody would have to do the work to get the right hand drive to work.
Plus fit kit.
Always pray for snow.
If I were going to bother doing it; It would get the Yeti not the TimberSled.
K
Lefthand kick a 700 in snow boots!? No thanks.
Timbersled had right hand drives.
I've been waiting for this.
I'm surprised someone hasn't built a snowbike out of one of these already???
I'm surprised someone hasn't built a snowbike out of one of these already???
G
way to hard to start that bike. you can however flip side plates and make a left hand drive a right hand drive. I 've seen it done on a Husa
DRAW BACKS
right drive no big deal, been done.
kickstarting the 700 ? my 800 pull starts so easy..........well ok 400times2, machined a head for 380 ktm using a HARLEY COMPRESSION RELEASE, started like a 125 or easier.
finding one of these..............now there's a challenge.
right drive no big deal, been done.
kickstarting the 700 ? my 800 pull starts so easy..........well ok 400times2, machined a head for 380 ktm using a HARLEY COMPRESSION RELEASE, started like a 125 or easier.
finding one of these..............now there's a challenge.
P
At elevation, the bigger cylinder, the harder it is to fill. especially looking at the bore/stroke specs.
i would be suprised if it ran any better than a cr500 past 6000ft
i would be suprised if it ran any better than a cr500 past 6000ft
A lot have been written about this bike but no snowbike so far...
Toby Till, Tillbullit posted some photos of a brand new Maico 700 unboxed on his Facebook a moth or two ago. That bike was about to go on the dyno and then have the kit assembled.
What happend to to it?
Toby Till, Tillbullit posted some photos of a brand new Maico 700 unboxed on his Facebook a moth or two ago. That bike was about to go on the dyno and then have the kit assembled.
What happend to to it?
The owner just posted on the Facebook page. He will be running that bike next year along with a kx500 in a new 16 ktm frame. The maico will be on a Timbersled sx137. The 500 on a yeti. Everyone will need to wait.
Sent from my iPhone using Tapatalk
Anything ever happen here?
Similar threads
