I
I've got threaded pins in my TRA. What's the correct length set screw to get it to stock weight? 03, MXZ 800. Thanks
TRA Threaded clutch pins
- Thread starter IL Renegade
- Start date
2003 all elevation specs
Look up your particular model and shows the pinweight and setscrew part numbers.
Pin legend for two BRP pins - From my website.
Look up your particular model and shows the pinweight and setscrew part numbers.
Pin legend for two BRP pins - From my website.
I
Thanks Joe! I was hoping to hear from you.
I've read my manual and dug through what you gave me. I plan to use my threaded pins and add the weight (set screws) back in to get it to the stock pin weight.
Can anybody tell me the solid pin weight?
Thanks again.
I've read my manual and dug through what you gave me. I plan to use my threaded pins and add the weight (set screws) back in to get it to the stock pin weight.
Can anybody tell me the solid pin weight?
Thanks again.
G
so im new to this so please forgive me if this a dumb question. i replaced the rollers in my clutch today it has threaded pins as well with no set screws should there be? i ride an 02 800 highmark 151. im 5 11 210 lbs.
we ride 6000 to 8000 elev.
we ride 6000 to 8000 elev.
@ IL Renegade - the weights are either 16.7g or 18.8g Pretty much the stock 800 rev had either of those two weights. Im gonna lean towards the 16g pinset is the correct one.
@ grizzman your pin is 10.8 g and empty is for 8000~12000 feet
1-10mm setscrew to make 12.1g for 4000~8000
@ grizzman your pin is 10.8 g and empty is for 8000~12000 feet
1-10mm setscrew to make 12.1g for 4000~8000
G
thanks for the help
can i pick up some set screws from the hardware store or are they a dealer item.
and could anyone recomend a place i could read up on clutching to better understand them. thanks
can i pick up some set screws from the hardware store or are they a dealer item.
and could anyone recomend a place i could read up on clutching to better understand them. thanks
You can get metric setscrews from a napa or local hardware/millwork store that supplies fasteners.
A local BRP dealer will have the setscrews mentioned on the sheet.
About clutching experiences
https://www.mxzx-revzone.com/article/self-guided-help-6.asp
About Clutching theory
https://www.mxzx-revzone.com/article/calibration-theory-and-application-8.asp
Run your mouse over top of the above links at the website, there is a few moments of reading.
A local BRP dealer will have the setscrews mentioned on the sheet.
About clutching experiences
https://www.mxzx-revzone.com/article/self-guided-help-6.asp
About Clutching theory
https://www.mxzx-revzone.com/article/calibration-theory-and-application-8.asp
Run your mouse over top of the above links at the website, there is a few moments of reading.
G
much apperciated set screws are in cant wait till saturday. frist ride
