S
was wondering where i could find a kit to relocat my back boggy wheels to the inside for better side hilling?
Tech help boggy wheels?
- Thread starter Snowholic
- Start date
M
slp in idaho about 65 bucks and an hour to install give or take a six pack
D
If your a do it your self person like i am, you can do it yourself and its free
M
do explain we would like to know your technique
u cant leave us hangin
share the steps to do it
has it held up
u cant leave us hangin
share the steps to do it
has it held up
D
cut the axle to 8 7/8"or 8 15/16" and the spacer to 4 1/4", after you cut the axle, drill it out as straight as you possible can and tap it with a 3/8" tap. You can just leave one side stock and use the 3/8s bolt on one side. i believe i used corse thread. Then you take the adusters and put them on the inside. after all this, you should get some thick aluminum washers to use on the outside for the bolts.
C
I just did this, however I wanted to use the stock bolt and stock style washer ( I made another on the lathe), to do it this way the spacer size is correct, but the axle needs to be 9 1/4" so that enough protrudes past the rail to center the washer on either side.
Similar threads
